AudioCodes Mediant 4000 SBC User Manual page 394

CHAPTER 18 Core Entities
'Message Manipulation User-
Defined String 2'
msg-man-user-defined-
string2
[IPGroup_MsgManUserDef2]
'Proxy Keep-Alive using IP Group
Settings'
proxy-keepalive-use-ipg
[ProxyKeepAliveUsingIPG]
SBC Registration and Authentication
'Max. Number of Registered
Users'
max-num-of-reg-users
[IPGroup_MaxNumOfRegUsers]
'Registration Mode'
Parameter Description
Defines a value for the SIP user part that can be used in
Message Manipulation rules configured in the Message
Manipulations table. The Message Manipulation rule
obtains this value from the IP Group, by using the
following syntax: param.ipg.<src|dst>.user-defined.<1>.
The valid value is a string of up to 30 characters. By
default, no value is defined.
To configure Message Manipulation rules, see
Configuring SIP Message
Enables the device to apply certain IP Group settings to
keep-alive SIP OPTIONS messages that are sent by the
device to the proxy server. The parameter is applicable
only if you have enabled proxy keep-alive for the Proxy
Set that is associated with the IP Group (see
Configuring Proxy Sets
■ [0] Disable = (Default) The IP Group's settings are
not applied to the OPTIONS messages.
■ [1] Enable = The following IP Group settings are
applied (if configured) to the proxy keep-alive SIP
OPTIONS messages:
✔
The IP Group's 'SIP Group Name' parameter
(see above) value is used in the OPTIONS
messages.
✔
The IP Group's 'Outbound Message
Manipulation Set' parameter (see above) is
applied to the OPTIONS messages (instead of
manipulations configured by the
GWOutboundManipulationSet parameter). You
can also use the manipulation syntax
"param.ipg.dst" for denoting the IP Group's
parameters.
✔
When filtering logs (configured in the Logging
Filters table), the OPTIONS messages are
filtered by IP Group. For more information on log
filtering, see Configuring Log Filter Rules
page 812.
Note: When multiple IP Groups are associated with the
same Proxy Set, the parameter can be enabled only on
one of them.
Defines the maximum number of users in this IP Group
that can register with the device.
The default is -1, meaning that no limitation exists for
registered users.
Note: The parameter is applicable only to User-type IP
Groups.
Defines the registration mode for the IP Group.
- 361 -
Mediant 4000 SBC | User's Manual
Manipulation.
on page 367).
on