Triggers For Automatic Update - AudioCodes Mediant 4000 SBC User Manual

CHAPTER 40 Automatic Provisioning
File Type
SSL/TLS Root Certificate file
SSL/TLS Certificate file

Triggers for Automatic Update

The Automatic Update feature can be triggered by the following:
■ Upon device startup (reset or power up). To disable this trigger, run the following CLI
command:
(config-system)# automatic-update
(automatic-update)# run-on-reboot off
■ Periodically:
● Specified time of day (e.g., 18:00), configured by the ini file parameter
AutoUpdatePredefinedTime or CLI command configure system > automatic-update >
predefined-time.
● Interval between Automatic Updates (e.g., every 60 minutes), configured by the ini file
parameter AutoUpdateFrequency or CLI command configure system > automatic-update
> update-frequency.
■ Centralized provisioning server request:
● Upon receipt of an SNMP request from the provisioning server.
● Upon receipt of a special SIP NOTIFY message from the provisioning server. The
NOTIFY message includes an Event header with the AudioCodes proprietary value,
"check-sync;reboot=false", as shown in the example below:
NOTIFY sip:<user>@<dsthost> SIP/2.0
To: sip:<user>@<dsthost>
From: sip:sipsak@<srchost>
CSeq: 10 NOTIFY
Call-ID: 1234@<srchost>
Event: check-sync;reboot=false
To enable the feature:
i.
ii.
iii.
To enable through CLI: configure voip > sip-definition advanced-settings > sip-remote-
reset.
sslr
sslc
Open the SIP Definitions General Settings page (Setup menu > Signaling & Media
tab > SIP Definitions folder > SIP Definitions General Settings).
From the 'Remote Management by SIP Notify' (EnableSIPRemoteReset) drop-down
list, select Enable:
Click Apply.
Keywords for
Template File
root.pem
root<ID>.pem (for multi-certificate
system)
cert.pem
cert<ID>.pem (for multi-certificate
system)
- 701 -
Mediant 4000 SBC | User's Manual
Value Replacing
<FILE> Placeholder