Configuring Sbc Ip-To-Ip Routing - AudioCodes Mediant 4000 SBC User Manual

CHAPTER 25 Routing SBC
'Request Type'
'Request Target'
'Request Key'
'Condition '
Action
'Action Subject'
'Action Type'
'Action Value'
3. Open the SIP Interfaces table (see
configure a SIP Interface with the 'Call Setup Rules Set ID' parameter set to the 'Rules Set ID'
value of your Call Setup Rules. In our example, the SIP Interface is named "SIPIfx-Tags" and
the parameter is configured to 1.
4. Open the Classification table, and then configure a rule with the following:
'Source SIP
Interface'
Action
'IP Group
Selection'
'IP Group Tag
Name'
5. Open the IP Groups table (see
Groups with the 'Tags' parameter set to the appropriate tag. If the source tag has a name and
value, then configure the parameter as name=value (e.g., "Country=Ireland"). If it only has a
value, then configure it with the value. In our example, the following IP Groups are configured:
IPGroup-1
IPGroup-2
IPGroup-3

Configuring SBC IP-to-IP Routing

The IP-to-IP Routing table lets you configure up to 3,750 SBC IP-to-IP routing rules.
Configuration of IP-to-IP routing rules includes two areas:
■ Match: Defines the characteristics of the incoming SIP dialog message (e.g., IP Group from
which the message is received).
Configuring SIP Interfaces
SIPIfx-Tags (or select Any)
Tagged IP Group
Country
Note: Enter the tag's name only. If the tag only has a value, then enter
"default".
Configuring IP Groups
Name
Country=Ireland
Country=Scotland
Country=England
General
Dial Plan
ITSP
Param.Call.Src.User
DialPlan.Found exists
SrcTags
Modify
DialPlan.Result
Match
on page 346), and then configure IP
Tags
- 545 -
Mediant 4000 SBC | User's Manual
on page 334), and then