Configuring Sip Recording Rules - AudioCodes Mediant 4000 SBC User Manual

CHAPTER 16 Services
</participant>
<stream stream_id="mBfiAAAAAL1hFQENAPA=" session_id="OWc4Md2PHao=">
<label>1</label>
</stream>
<stream stream_id="hBfiAAAAAL1hFQENAPA=" session_id="OWc4Md2PHao=">
<label>2</label>
</stream>
<sessionrecordingassoc session_id="OWc4Md2PHao=">
<associate-time>2018-04-17T09:35:41</associate-time>
</sessionrecordingassoc>
<participantsessionassoc participant_id="MjAw" session_id="OWc4Md2PHao=">
<associate-time>2018-04-17T09:35:41</associate-time>
</participantsessionassoc>
<participantsessionassoc participant_id="MTAw" session_id="OWc4Md2PHao=">
<associate-time>2018-04-17T09:35:41</associate-time>
</participantsessionassoc>
<participantstreamassoc participant_id="MjAw">
<send>mBfiAAAAAL1hFQENAPA=</send>
<recv>hBfiAAAAAL1hFQENAPA=</recv>
</participantstreamassoc>
<participantstreamassoc participant_id="MTAw">
<send>hBfiAAAAAL1hFQENAPA=</send>
<recv>mBfiAAAAAL1hFQENAPA=</recv>
</participantstreamassoc>
</recording>

Configuring SIP Recording Rules

The SIP Recording Rules table lets you configure up to 30 SIP-based media recording rules. A SIP
Recording rule defines call routes that you want to record. For an overview of the feature, see
based Media
●
●
●
The following procedure describes how to configure SIP Recording rules through the Web interface.
You can also configure it through ini file [SIPRecRouting] or CLI (configure voip > sip-
definition sip-recording sip-rec-routing).
➢
To configure a SIP Recording Routing rule:
1. Open the SIP Recording Rules table (Setup menu > Signaling & Media tab > SIP Record-
ing folder > SIP Recording Rules).
2. Click New; the following dialog box appears:
Recording.
To view the total number of currently active SIPRec signaling sessions, use the
CLI command show voip calls statistics siprec. For more information, refer to
the CLI Reference Guide.
To configure the device's timestamp format (local or UTC) in SIP messages sent to
the SRS, see the SIPRecTimeStamp parameter.
When recording SRTP-to-SRTP calls, if you want to send the recorded media to
the SRS as RTP (i.e., decrypted), you need to add an IP Profile for the SRS and
configure its' 'SBC Media Security Mode' parameter to RTP . To configure IP
Profiles, see Configuring IP Profiles on page 395.
- 200 -
Mediant 4000 SBC | User's Manual
SIP-