CHAPTER 20 SIP Definitions
The figure below illustrates the GIN registration process:
The figure below illustrates an incoming call using GIN:
Registrar Stickiness
You can enable the Registrar Stickiness feature per Account. Registrar Stickiness binds an
Account to one of the IP addresses (configured or DNS-resolved) in the Proxy Set associated with
the Serving IP Group. Once an Account registers successfully to one of the IP addresses (i.e., SIP
registrar server) in the Proxy Set, the device routes all subsequent SIP requests (INVITEs,
SUBSCRIBEs and REGISTER refreshes) of the Account to this registrar. This applies until the
registrar is unreachable or registration refresh fails, for whatever reason.
To configure the Registrar Stickiness feature, use the following parameters in the Accounts table:
■
Registrar Stickiness: Enables the feature.
■
Registrar Search Mode: Defines the method for choosing an IP address (registrar) in the Proxy
Set to which the Account initially registers and performs registration refreshes. Once chosen,
the Account is binded to this registrar.
■
Reg Event Package Subscription: Enables the device to subscribe to the registration event
package service (as defined in RFC 3680) with the registrar to which the Account is registered
and binded. The service allows the device to receive notifications of the Accounts registration
state change with the registrar.
Configuring Proxy and Registration Parameters
The Proxy & Registration page allows you to configure the Proxy server and registration
parameters. For a description of the parameters appearing on this page, see
Parameters
Reference. To configure Proxy servers (Proxy Sets), see
- 444 -
Mediant 4000 SBC | User's Manual
Configuration
Configuring Proxy
Sets.