Srtp Parameters - AudioCodes Mediant 4000 SBC User Manual

CHAPTER 60 Configuration Parameters Reference
'Secured Web Connection
(HTTPS)'
configure system > web >
secured-connection
[HTTPSOnly]
configure system > web >
https-port
[HTTPSPort]
'Require Client Certificates for
HTTPS connection'
configure system > web >
req-client-cert
[HTTPSRequireClientCertificate]

SRTP Parameters

The Secure Real-Time Transport Protocol (SRTP) parameters are described in the table below.
'Media Security'
configure voip > media security >
media-security-enable
[EnableMediaSecurity]
Table 60-22:HTTPS Parameters
Parameter
Table 60-23:SRTP Parameters
Parameter
Description
Defines the protocol for accessing the Web interface.
■ [0] HTTP and HTTPS (default)
■ [1] HTTPs Only = Unencrypted HTTP packets are
blocked.
Note: For the parameter to take effect, a device reset is
required.
Defines the local Secured HTTPS port of the device. The
parameter allows secure remote device Web
management from the LAN. To enable secure Web
management from the LAN, configure the desired port.
The valid range is 1 to 65535 (other restrictions may apply
within this range). The default port is 443.
Note: For the parameter to take effect, a device reset is
required.
Enables the requirement of client certificates for HTTPS
connection.
■ [0] Disable = (Default) Client certificates are not
required.
■ [1] Enable = Client certificates are required. The
client certificate must be preloaded to the device and
its matching private key must be installed on the
managing PC. Time and date must be correctly set on
the device for the client certificate to be verified.
Note:
■ For the parameter to take effect, a device reset is
required.
■ For a description on implementing client certificates,
see TLS for Remote Device
Enables Secure Real-Time Transport
Protocol (SRTP).
■ [0] Disable (default)
■ [1] Enable
Note:
- 906 -
Mediant 4000 SBC | User's Manual
Management.
Description