AudioCodes Mediant 4000 SBC User Manual page 587

CHAPTER 25 Routing SBC
Parameter
'ReRoute IP Group'
re-route-ip-
group-id
[IP2IPRouting_
ReRouteIPGroupNam
e]
Action
'Destination Type'
dst-type
[IP2IPRouting_
DestType]
■ [5] Broken Connection = If the device detects a broken RTP
connection during the call and the Broken RTP Connection
feature is enabled (IpProfile_DisconnectOnBrokenConnection
parameter is configured to [2]), you can use this option as an
explicit matching characteristics to route the call to an
alternative destination. Therefore, for alternative routing upon
broken RTP detection, position the routing rule configured with
this option above the regular routing rule associated with the call.
Such a configuration setup ensures that the device uses this
alternative routing rule only when RTP broken connection is
detected.
■ [6] Fax Rerouting = Reroutes the INVITE to a fax destination
(different IP Group) if it is identified as a fax call. For more
information, see Configuring Rerouting of Calls to Fax
Destinations.
Defines the IP Group that initiated (sent) the SIP redirect response
(e.g., 3xx) or REFER message. This parameter is typically used for
rerouting requests (e.g., INVITEs) when interworking is required for
SIP 3xx redirect responses or REFER messages. For more
information, see Interworking SIP 3xx Redirect Responses
Interworking SIP REFER
functions together with the 'Call Trigger' parameter (in the table).
The default is Any (i.e., any IP Group).
Note: The selectable IP Group for the parameter depends on the
assigned Routing Policy (in the 'Routing Policy' parameter in this
table). For more information, see
Rules.
Determines the destination type to which the outgoing SIP dialog is
sent.
■ [0] IP Group = (Default) The SIP dialog is sent to the IP Group
as defined in the 'Destination IP Group' (IP2IPRouting_
DestIPGroupName) parameter. For more information on the
actual address, see the 'Destination IP Group' parameter.
■ [1] Dest Address = The SIP dialog is sent to the address
configured in the following parameters: 'Destination Address',
'Destination Port' and 'Destination Transport Type'.
■ [2] Request URI = The SIP dialog is sent to the address
indicated in the incoming Request-URI. If the parameters
'Destination Port' and 'Destination Transport Type' are
configured, the incoming Request-URI parameters are
overridden and these parameters take precedence.
■ [3] ENUM = An ENUM query is sent to include the destination
address. If the parameters 'Destination Port' and 'Destination
Transport Type' are configured, the incoming Request-URI
parameters are overridden and these parameters take
precedence.
- 554 -
Mediant 4000 SBC | User's Manual
Description
Messages, respectively. The parameter
Configuring SBC Routing Policy
and