Installing License Key Through Cli; Verifying Installed License Key - AudioCodes Mediant 4000 SBC User Manual

CHAPTER 38 License Key
When installation completes, the following message box appears:
6. Clock Close to close the message box; you are logged out of the Web interface and prompted
to log in again. The features and capabilities displayed on the License Key page now reflect the
newly installed License Key.

Installing License Key through CLI

To install the License Key through CLI, use the following commands:
■ To install the License Key:
(config-system)# feature-key <"string enclosed in double quotation marks">
■ To view the License Key:
show system feature-key

Verifying Installed License Key

Once you have finished installing the new License Key, verify that it has been installed:
1. On the License Key page, check that the listed features and capabilities of the newly installed
License Key match those that you ordered.
2. Access the Syslog server and check that the following message appears:
"S/N<serial number> Key Was Updated. The Board Needs to be Reloaded with ini file\n"
If the Syslog server indicates that the License Key was unsuccessfully loaded (i.e., the "SN_"
line is blank), do the following preliminary troubleshooting procedures:
a. Open the License Key file and check that the "S/N" line appears. If it does not appear,
contact the sales representative of your purchased device.
b. Verify that you have loaded the correct file. Open the file and ensure that the first line
displays "[LicenseKeys]".
c. Verify that the content of the file has not been altered.
- 680 -
Mediant 4000 SBC | User's Manual