AudioCodes Mediant 4000 SBC User Manual page 902

CHAPTER 60 Configuration Parameters Reference
configure system > snmp settings
> port
[SNMPPort]
[ChassisPhysicalAlias]
[ChassisPhysicalAssetID]
[ifAlias]
configure system > snmp trap >
auto-send-keep-alive
[SendKeepAliveTrap]
Parameter
- 869 -
Mediant 4000 SBC | User's Manual
Description
Note: For the parameter to take effect, a
device reset is required.
Defines the device's local (LAN) UDP port
used for SNMP Get/Set commands.
The range is 100 to 3999. The default port is
161.
Note: For the parameter to take effect, a
device reset is required.
Defines the 'alias' name object for the
physical entity as specified by a network
manager, and provides a non-volatile
'handle' for the physical entity.
The valid range is a string of up to 255
characters.
Defines the user-assigned asset tracking
identifier object for the device's chassis as
specified by OVOC, and provides non-
volatile storage of this information.
The valid range is a string of up to 255
characters.
Defines the textual name of the interface.
The value is equal to the ifAlias SNMP MIB
object.
The valid range is a string of up to 64
characters.
Enables the device to send NAT keep-alive
traps to the port of the SNMP network
management station (e.g., AudioCodes
OVOC). This is used for NAT traversal, and
allows SNMP communication with OVOC
management platform, located in the WAN,
when the device is located behind NAT. It is
needed to keep the NAT pinhole open for the
SNMP messages sent from OVOC to the
device. The device sends the trap
periodically - every 9/10 of the time
configured by the
NATBindingDefaultTimeout parameter. The
trap that is sent is acKeepAlive. For more
information on the SNMP trap, refer to the
SNMP Reference Guide.
■ [0] = (Default) Disable
■ [1] = Enable
To configure the port number, use the
KeepAliveTrapPort parameter.
Note: For the parameter to take effect, a
device reset is required.