AudioCodes Mediant 4000 SBC User Manual page 616

CHAPTER 26 SBC Manipulations
●
●
The following procedure describes how to configure Outbound Manipulations rules through the Web
interface. You can also configure it through ini file [IPOutboundManipulation] or CLI (configure
voip > sbc manipulation ip-outbound-manipulation).
➢
To configure Outbound Manipulation rules:
1. Open the Outbound Manipulations table (Setup menu > Signaling & Media tab > SBC folder
> Manipulation > Outbound Manipulations).
2. Click New; the following dialog box appears:
3. Configure an Outbound Manipulation rule according to the parameters described in the table
below.
4. Click Apply.
Table 26-2: Outbound Manipulations Table Parameter Description
Parameter
'Routing Policy'
routing-policy-name
[IPOutboundManipulation_
RoutingPolicyName]
Configure stricter classification rules higher up in the table than less strict rules to
ensure the desired rule is used to manipulate the outbound dialog. Strict refers to
the number of matching characteristics configured for the rule. For example, a rule
configured with source host name and source IP Group as matching characteristics
is stricter than a rule configured with only source host name. If the rule configured
with only source host name appears higher up in the table, the device
("erroneously") uses the rule to manipulate outbound dialogs matching this source
host name (even if they also match the rule appearing lower down in the table
configured with the source IP Group as well).
SIP URI host name (source and destination) manipulations can also be configured
in the IP Groups table (see
host name substitutions with the names configured for the source and destination
IP Groups, respectively.
Assigns a Routing Policy to the rule. The Routing Policy
associates the rule with an SRD(s). The Routing Policy also
defines default LCR settings as well as the LDAP servers if the
routing rule is based on LDAP routing (and Call Setup Rules).
If only one Routing Policy is configured in the Routing Policies
table, the Routing Policy is automatically assigned. If multiple
Routing Policies are configured, no value is assigned.
To configure Routing Policies, see
Policy
Note: The parameter is mandatory.
Configuring IP Groups). These manipulations are simply
Description
Rules.
- 583 -
Mediant 4000 SBC | User's Manual
Configuring SBC Routing