Auxiliary And Configuration File Name Parameters - AudioCodes Mediant 4000 SBC User Manual
Session border controllers
Hide thumbs
Also See for Mediant 4000 SBC:
- User manual (964 pages) ,
- Hardware installation manual (40 pages) ,
- User manual (930 pages)
Table of Contents
Advertisement
CHAPTER 60 Configuration Parameters Reference
Auxiliary and Configuration File Name Parameters
The table below lists the parameters associated with the Auxiliary files. For more information on
Auxiliary files, see
Table 60-7: Auxiliary and Configuration File Parameters
Parameter
General Parameters
[SetDefaultOnIniFileProcess]
[SaveConfiguration]
Auxiliary Filename Parameters
'Call Progress Tones File'
[CallProgressTonesFilename]
'Prerecorded Tones File'
[PrerecordedTonesFileName]
'Dial Plan File'
[DialPlanFileName]
[UserInfoFileName]
Loading Auxiliary
Files.
Determines if all the device's parameters are set to their
defaults before processing the updated ini file.
■
[0] = Disable - parameters not included in the downloaded
ini file are not returned to default settings (i.e., retain their
current settings).
■
[1] = Enable (default).
Note: The parameter is applicable only for automatic HTTP
update or Web ini file upload (not applicable if the ini file is
loaded using BootP).
Determines if the device's configuration (parameters and
files) is saved to flash (non-volatile memory).
■
[0] = Configuration isn't saved to flash memory.
■
[1] = (Default) Configuration is saved to flash memory.
Defines the name of the file containing the Call Progress
Tones definitions.
For the ini file, the name must be enclosed by single
apostrophes, for example, 'cpt_us.dat'.
For more information on how to create and load this file, refer
to DConvert Utility User's Guide.
Note: For the parameter to take effect, a device reset is
required.
Defines the name of the file containing the Prerecorded
Tones.
Note:
■
For the parameter to take effect, a device reset is
required.
Defines the name of the Dial Plan file.
For the ini file, the name must be enclosed by single
apostrophes, for example, 'dial_plan.dat'.
Note: This parameter is used only for backward
compatibility. For loading (importing) Dial Plan files, use the
Dial Plan table instead (see
page 468).
Defines the name of the file containing the User Information
data.
- 875 -
Mediant 4000 SBC | User's Manual
Description
Importing Dial Plans
on
Advertisement
Table of Contents
Troubleshooting
