AudioCodes Mediant 4000 SBC User Manual page 827

CHAPTER 51 Reporting Information to External Party
Field
Termination
Reason
Value
[437]
Termination
Reason
[410]
Note:
■ The field is included in the default CDR.
■ The field is applicable only to "CALL_END" CDR Report Types.
■ The field is applicable only to SBC signaling and Gateway CDRs.
■ The default field title is "TrmReasonCategory" for Syslog and Local
Storage, and "Termination Reason" for Web CDR History.
■ The maximum number of characters for Syslog tabular alignment is 17.
Displays the Q.850 reason codes (1-127) for call termination. For example, "16"
for Normal Termination.
Note:
■ The field is included in the default CDR for RADIUS CDRs.
■ The field is applicable only to "CALL_END" CDR Report Types.
■ The field is applicable only to SBC signaling and Gateway CDRs.
■ The default field title is "h323-disconnect-cause=" (e.g., "h323-disconnect-
cause=16").
■ The maximum number of characters for Syslog tabular alignment is 5.
Displays the reason for the call termination. The field value is a string of up to
40 characters and is set to one of the following:
■ Standard Call Termination Reasons:
✔
"GWAPP_UNASSIGNED_NUMBER"
✔
"GWAPP_NO_ROUTE_TO_TRANSIT_NET"
✔
"GWAPP_NO_ROUTE_TO_DESTINATION"
✔
"GWAPP_SEND_SPECIAL_INFORMATION_TONE"
✔
"GWAPP_MISDIALED_TRUNK_PREFIX"
✔
"GWAPP_CHANNEL_UNACCEPTABLE"
✔
"GWAPP_CALL_AWARDED_AND"
✔
"GWAPP_PREEMPTION"
✔
"PREEMPTION_CIRCUIT_RESERVED_FOR_REUSE"
✔
"GWAPP_NORMAL_CALL_CLEAR"
✔
"GWAPP_USER_BUSY"
✔
"GWAPP_NO_USER_RESPONDING"
✔
"GWAPP_NO_ANSWER_FROM_USER_ALERTED"
✔
"MFCR2_ACCEPT_CALL"
✔
"GWAPP_CALL_REJECTED"
✔
"GWAPP_NUMBER_CHANGED"
✔
"GWAPP_REDIRECTION"
✔
"GWAPP_EXCHANGE_ROUTING_ERROR"
✔
"GWAPP_NON_SELECTED_USER_CLEARING"
✔
"RELEASE_BECAUSE_TRUNK_DISCONNECTED"
✔
"GWAPP_INVALID_NUMBER_FORMAT"
✔
"GWAPP_FACILITY_REJECT"
✔
"GWAPP_RESPONSE_TO_STATUS_ENQUIRY"
- 794 -
Mediant 4000 SBC | User's Manual
Description