AudioCodes Mediant 4000 SBC User Manual page 592

CHAPTER 25 Routing SBC
Parameter
'Internal Action'
internal-action
[IP2IPRouting_
InternalAction]
The default value is "default", meaning that the device uses the first
tag name in the Dial Plan rule that is configured without a value. For
example, if the Dial Plan rule is configured with tags
"Country=England;City=London;Essex", the default tag is "Essex".
For more information on using tags to determine destination IP
Group, see Using Dial Plan Tags for Routing
Note: The parameter is applicable only if the 'Destination Type'
parameter is configured to Destination Tag (see above).
Defines a SIP response code (e.g., 200 OK) or a redirection
response (with an optional Contact field indicating to where the
sender must re-send the message) that the device sends to the
sender of the incoming SIP dialog (instead of sending the call to
another destination). The parameter is applicable only when the
'Destination Type' parameter in this table is configured to Internal
(see above).
The valid value syntax (case-insensitive) is:
■ For SIP response codes:
reply(response='<code>')
The following example sends a SIP 200:
reply(response='200')
■ For redirection responses:
redirect(response='<code>',contact='sip:'+....)
redirect(contact='...',response='<code>')
redirect(contact='sip:user@host')
Examples:
✔
The device responds to the dialog with a SIP 300 redirect
response that includes a contact value:
redirect(response='300',contact='sip:102@host')
✔
The device redirects the call from the sender to a SIP
Recording Server (SRS):
redirect
(response='302',contact='sip:'+header.to.url.user+'@sipreco
rding.com')
You can use the built-in syntax editor to help you configure the field.
Click the Editor button located alongside the field to open the
Editor, and then simply follow the on-screen instructions.
- 559 -
Mediant 4000 SBC | User's Manual
Description
Destinations.