AudioCodes Mediant 4000 SBC User Manual page 79

CHAPTER 6 Web-Based Management
Parameter
'Web Session Limit'
session-limit
[WebUsers_
SessionLimit]
'CLI Session Limit'
cli-session-limit
[WebUsers_
CliSessionLimit]
'Web Session Timeout'
session-timeout
[WebUsers_
SessionTimeout]
'Block Duration'
block-duration
[WebUsers_BlockTime]
Note: After logging in with your new password, you must save
your settings, by clicking the Save button on the Web interface's
toolbar. If not, the next time you attempt to log in, you will be
prompted again to change the expired password.
Defines the maximum number of concurrent Web interface and
REST sessions allowed for the specific user account. For
example, if configured to 2, the user account can be logged into
the device's Web interface (i.e., same username-password
combination) from two different management stations (i.e., IP
addresses) or Web browsers at the same time. Once the user logs
in, the session is active until the user logs off or until the session
expires if the user is inactive for a user-defined duration (see the
'Web Session Timeout' parameter below).
The valid value is 0 to 10. The default is 5.
Note:
■ Closing the Web browser's window (by clicking the window's
x button) does not end the session. Therefore, whenever you
finish using the Web interface, it is recommended that you log
out of the Web interface so that your session ends.
■ If the number of concurrently logged-in users is at the
configured maximum, the device allows an additional user to
log in through REST.
Defines the maximum number of concurrent CLI sessions allowed
for the specific user. For example, if configured to 2, the same
user account can be logged into the device's CLI (i.e., same
username-password combination) from two different management
stations (i.e., IP addresses) at any one time. Once the user logs
in, the session is active until the user logs off or until the session
expires if the user is inactive for a user-defined duration (see the
'Web Session Timeout' parameter below).
The valid value is -1, or 0 to 100. The default is -1, which means
that the limit is according to the global parameters, 'Maximum
Telnet Sessions' (TelnetMaxSessions) or 'Maximum SSH
Sessions' (SSHMaxSessions).
Defines the duration (in minutes) of inactivity of a logged-in user in
the Web interface, after which the user is automatically logged off
the Web session. In other words, the session expires when the
user has not performed any operations (activities) in the Web
interface for the configured timeout duration.
The valid value is 0, or to 100000. A value of 0 means no timeout.
The default value is according to the settings of the
WebSessionTimeout global parameter (see
Session and Access Settings).
Defines the duration (in seconds) for which the user is blocked
when the user exceeds a user-defined number of failed login
attempts.
- 46 -
Mediant 4000 SBC | User's Manual
Description
Configuring Web