Customizing Access Levels Per Web Page - AudioCodes Mediant 4000 SBC User Manual

CHAPTER 6 Web-Based Management
Parameter

Customizing Access Levels per Web Page

The Customize Access Level table lets you configure up to 100 customized access rules. These
rules assign read-write (view and configure) and read-only (view) privileges to management user
levels (Monitor, Administrator, or Security Administrator) per page in the device's Web interface.
These rules override the default read-write and read-only privileges of the user levels (as described
in Configuring Management User Accounts
applies to that level as well as all levels that are higher than that level (the Security Administrator
user is the highest user level and the Monitor user the lowest level).
The following table provides a few configuration examples to facilitate the understanding of assign-
ing read-write and read-only privileges to user levels per Web page.
Page Name
CLI Settings
The valid value is 0 to 100000, where 0 means that the user can
do as many login failures without getting blocked. The default is
according to the settings of the 'Deny Authentication Timer'
parameter (see
Note:
■ To enable this feature, see the 'Deny Access On Fail Count'
parameter in
■ The 'Deny Authentication Timer' parameter relates to failed
Web logins from specific IP addresses.
on page 41). Whatever user level is specified, the rule
Read-Write Access Level
Monitor
- 47 -
Mediant 4000 SBC | User's Manual
Description
Configuring Web Session and Access
Configuring Web Session and Access
Read-Only Access Level
Monitor
Settings).
Settings.
Description
Assigns read-
write (and read-
only) privileges
to Monitor users
for the CLI
Settings page.
As this is the
lowest user
level, it means
that all higher
user levels (i.e.,
Administrator
and Security
Administrator)
are also
assigned full
read-write
privileges.