AudioCodes Mediant 4000 SBC User Manual page 618

CHAPTER 26 SBC Manipulations
Parameter
'Source IP Group'
src-ip-group-name
[IPOutboundManipulation_
SrcIPGroupName]
'Destination IP Group'
dst-ip-group-name
[IPOutboundManipulation_
DestIPGroupName]
'Source Username Pattern'
src-user-name-
pattern
[IPOutboundManipulation_
SrcUsernamePrefix]
'Source Host'
src-host
[IPOutboundManipulation_
SrcHost]
'Source Tags'
src-tags
[IPOutboundManipulation_
SrcTags]
'Destination Username
Pattern'
Defines the IP Group from where the INVITE is received.
The default value is Any (i.e., any IP Group).
Defines the IP Group to where the INVITE is to be sent.
The default value is Any (i.e., any IP Group).
Defines the source SIP URI user name (typically used in the SIP
From header).
You can use special patterns (notations) to denote the user part.
For example, if you want to match this rule to user parts whose
last four digits (i.e., suffix) are 4 followed by any three digits
(e.g., 4008), then configure this parameter to "(4xxx)". For
available patterns, see Dialing Plan Notation for Routing and
Manipulation.
The valid value is a string of up to 60 characters. The default
value is the asterisk (*) symbol, meaning any source user part.
Note: If you need to manipulate calls of many different source
URI user parts, you can use tags (see 'Source Tags' parameter
below) instead of this parameter.
Defines the source SIP URI host name - full name, typically in
the From header.
The default value is the asterisk (*) symbol (i.e., any source host
name).
Assigns a prefix tag to denote source URI user names
corresponding to the tag configured in the associated Dial Plan.
The valid value is a string of up to 70 characters. The tag is case
insensitive. By default, no value is defined. You can configure
the parameter with up to five tags, where each tag is separated
by a semicolon (;). Each tag can have a name and value (e.g.,
Country=Ireland) or only a value (e.g., Ireland). If you are
configuring multiple tags in the name=value format, the names of
each tag must be unique (e.g.,
Country=Ireland;Land=Scotland).
To configure prefix tags, see
Note:
■ Make sure that you assign the Dial Plan in which you have
configured the prefix tag, to the related IP Group or SRD.
■ Instead of using tags and configuring the parameter, you can
use the 'Source Username Pattern' parameter to specify a
specific URI source user or all source users.
Defines the destination SIP URI user part (typically located in
the Request-URI and To headers).
- 585 -
Mediant 4000 SBC | User's Manual
Description
Configuring Dial Plans.