Configuring Http Directives - AudioCodes Mediant 4000 SBC User Manual

CHAPTER 16 Services
Table 16-25:HTTP Directive Sets Table Parameter Descriptions
Parameter
'Index'
[HTTPDirectiveSets_
Index]
'Set Name'
set-name
[HTTPDirectiveSets_
SetName]
'Description'
set-description
[HTTPDirectiveSets_
Description]

Configuring HTTP Directives

The HTTP Directives table lets you configure up to 500 HTTP Directives. The table is a "child" of
the HTTP Directive Sets table (see
The following procedure describes how to configure HTTP Directives through the Web interface.
You can also configure it through ini file [HTTPDirectives] or CLI (configure network >
http-proxy > directives).
➢
To configure an HTTP Directive:
1. Open the HTTP Directive Sets table (Setup menu > IP Network tab > HTTP Proxy folder >
HTTP Directive Sets).
2. In the table, select the required HTTP Directive Set index row, and then click the HTTP
Directives link located below the table; the HTTP Directives table appears.
3. Click New; the following dialog box appears:
4. Configure an HTTP Directive according to the parameters described in the table below.
5. Click Apply, and then save your settings to flash memory.
Table 16-26:HTTP Directives Table Parameter Descriptions
Parameter
'Index'
[HTTPDirectives_
RowIndex]
Defines an index number for the new table row.
Note:
■ Each row must be configured with a unique index.
■ The parameter is mandatory.
Defines a descriptive name, which is used when associating the row
in other tables.
The valid value is a string of up to 40 characters. By default, no value
is defined.
Note: The parameter value cannot contain a forward slash (/).
Defines a brief description for the HTTP Directive Set.
The valid value is a string of up to 100 characters. By default, no value
is defined.
Configuring HTTP Directive Sets
Defines an index number for the new table row.
Note:
■ Each row must be configured with a unique index.
- 277 -
Mediant 4000 SBC | User's Manual
Description
on page 275).
Description