AudioCodes Mediant 4000 SBC User Manual page 45

CHAPTER 4 Configuring VoIP LAN Interface for OAMP
➢
To configure the OAMP IP address through CLI:
1. Connect the RS-232 port of the device to the serial communication port on your computer. For
more information, refer to the Hardware Installation Manual.
2. Establish serial communication with the device using a terminal emulator program such as
HyperTerminal, with the following communication port settings:
● Baud Rate: 115,200 bps
● Data Bits: 8
● Parity: None
● Stop Bits: 1
● Flow Control: None
3. At the CLI prompt, type the username (default is "Admin" - case sensitive):
Username: Admin
4. At the prompt, type the password (default is "Admin" - case sensitive):
Password: Admin
5. At the prompt, type the following:
enable
6. At the prompt, type the password again:
Password: Admin
7. Access the Network configuration mode:
# configure network
8. Access the IP Interfaces table:
- 12 -
Mediant 4000 SBC | User's Manual