Radius-Based Services; Enabling Radius Services - AudioCodes Mediant 4000 SBC User Manual

CHAPTER 16 Services
Parameter
Condition
Action Subject
Action Type
Action Value
Row Rule
Index
Name
Manipulation Set ID
Message Type
Condition
Action Subject
Action Type
Action Value
Row Rule
b. Assign the above manipulation rules to the relevant IP Groups:
◆
◆

RADIUS-based Services

The device supports Remote Authentication Dial In User Service (RADIUS) by acting as a
RADIUS client. You can use RADIUS for the following:
■ Authentication and authorization of management users (login username and password) to gain
access to the device's management interface.
■ Accounting where the device sends accounting data of SIP calls as call detail records (CDR)
to a RADIUS Accounting server (for third-party billing purposes).

Enabling RADIUS Services

Before you can implement any RADIUS services, you must enable the RADIUS feature, as
described in the procedure below.
➢
To enable RADIUS:
1. Open the Authentication Server page (Setup menu > Administration tab > Web & CLI folder
> Authentication Server).
Var.Session.0 regex (.*),(.*),(.*)
Header.My-header2
Add
$2
Use Previous Condition
3
Send My-header3 to SRS
12
Invite.Request
Var.Session.0 regex (.*),(.*),(.*)
Header.My-header3
Add
$3
Use Previous Condition
In the IP Group of the recorded call leg which sends this header, configure the
'Inbound Message Manipulation Set' parameter to 11 (i.e., rule configured in Index 0).
In the IP Group of the SRS, configure the 'Outbound Message Manipulation Set'
parameter to 12 (i.e., rules configured in Index 1, 2 and 3).
Value
- 207 -
Mediant 4000 SBC | User's Manual