AudioCodes Mediant 4000 SBC User Manual page 927

CHAPTER 60 Configuration Parameters Reference
'Media CDR Report Level'
configure troubleshoot
> cdr > media-cdr-rprt-
level
[MediaCDRReportLevel]
'REST CDR Report Level'
configure system > cdr
> rest-cdr-report-level
[RestCdrReportLevel]
Parameter Description
■ [3] Connect & End Call = CDR report is sent to
Syslog at connection and at the end of each call.
■ [4] Start & End & Connect Call = CDR report is sent
to Syslog at the start, at connection, and at the end of
each call.
Note:
■ The parameter enables only signaling-related CDRs.
To enable media-related CDRs for SBC calls, use the
[MediaCDRReportLevel] parameter.
■ The CDR Syslog message complies with RFC 3164
and is identified by: Facility = 17 (local1) and Severity =
6 (Informational).
■ This mechanism is active only when Syslog is enabled
(i.e., the parameter [EnableSyslog] is set to [1]).
Enables media-related CDRs of SBC calls to be sent to a
Syslog server and defines the call stage at which they are
sent.
■ [0] None = (Default) No media-related CDR is sent.
■ [1] End Media = Sends a CDR only at the end of the
call.
■ [2] Start & End Media = Sends a CDR once the
media starts. In some calls it may only be after the call
is established, but in other calls the media may start at
ringback tone. A CDR is also sent upon termination
(end) of the media in the call.
■ [3] Update & End Media = Sends a CDR when an
update occurs in the media of the call. For example, a
call starts and a ringback tone occurs, a re-INVITE is
sent for a fax call and as a result, a CDR with the
MediaReportType field set to "Update" is sent, as the
media was changed from voice to T.38. A CDR is also
sent upon termination (end) of the media in the call.
■ [4] Start & End & Update Media = Sends a CDR at
the start of the media, upon an update in the media (if
occurs), and at the end of the media.
Note:
■ To enable CDR generation as well as enable signaling-
related CDRs, use the CDRReportLevel parameter.
Enables signaling-related CDRs to be sent to a REST
server and defines the call stage at which they are sent.
■ [0] None = (Default) CDRs are not sent.
■ [1] End Call = CDRs are sent at the end (SIP BYE) of
each call.
■ [2] Start & End Call = CDRs are sent at the start (SIP
INVITE) and end of each call.
■ [3] Connect & End Call = CDRs are sent at call
connection (200 OK) and end of each call.
- 894 -
Mediant 4000 SBC | User's Manual