AudioCodes Mediant 4000 SBC User Manual page 778

CHAPTER 47 Viewing Performance Monitoring
'SIP Method'
[UserDefinedFailurePM_Method]
'SIP Reason Code'
[UserDefinedFailurePM_
SIPReason]
'Internal Reason Code'
[UserDefinedFailurePM_
InternalReason]
Parameter Description
Defines the SIP method to which the rule is applied.
■ [1] INVITE = (Default) The PM MIB counts only
responses that are associated with INVITE
messages.
■ [3] REGISTER = The PM MIB counts only responses
that are associated with REGISTER messages.
These messages apply to registration failures,
including device-initiated registrations according to the
User Information table and Accounts table.
Defines the SIP failure reason(s) to count. This is the
response that is received due to the sent SIP method,
configured in the 'SIP Method' parameter (above).
The valid value is a SIP response code. You can configure
a range of response codes, using the "xx" character (e.g.,
4xx). You can configure the parameter with multiple
codes, where each code is separated by a comma (e.g.,
408,430,5xx). To denote all SIP response codes,
configure the parameter to "any".
Note: For the device to apply the rule, you must configure
this parameter and/or the 'Internal Reason Code'
parameter (below).
Defines the failure reason(s) that is generated internally by
the device to count. This response is generated due to the
sent SIP method, configured in the 'SIP Method'
parameter (above).
The valid value is a number representing the internal
reason, as shown in the table below. You can configure
the parameter with multiple reasons, where each number
is separated by a comma (e.g., 1,3,17). To denote all SIP
responses, configure the parameter to "All".
Value
1 Unassigned Number (GWAPP_
UNASSIGNED_NUMBER)
3 No Route To Destination (GWAPP_NO_
ROUTE_TO_DESTINATION)
17 User Busy (GWAPP_USER_BUSY)
18 No User Responding (GWAPP_NO_
USER_RESPONDING)
19 Alert Timeout (GWAPP_NO_ANSWER_
FROM_USER_ALERTED)
21 Call Rejected (GWAPP_CALL_
REJECTED)
- 745 -
Mediant 4000 SBC | User's Manual
Failure Reason