Suzuki Wagon R Manual page 1742

17) Repeat Steps 2) through 16) to deploy/activate air bag (infla-
tor) modules and seat belt pretensioners which has not been
deployed/activated, if any.
18) In the unlikely event that air bag (inflator) module and seat
belt pretensioner after following these procedures, proceed
immediately with Step 24) through 26). If air bag (inflator)
module and seat belt pretensioner did deploy/activate, pro-
ceed with Steps 19) through 23).
19) Carefully remove drop cloth from vehicle and clean off any
fragments or discard it entirely.
20) Put on pair of shop gloves to protect your hands from possi-
ble irritation and heat when handling deployed air bag (infla-
tor) module and activated seat belt pretensioner.
21) Disconnect adapter cable (special tool) from air bag (inflator)
module or seat belt pretensioner as soon as possible. This
will prevent adapter cable (special tool) from damage due to
possible contact with hot air bag (inflator) module or hot seat
belt pretensioner.
22) Check adapter cable connector as follows.
• For air bag (inflator) module :
Air bag (inflator) module connector of adapter cable (special
tool) are designed to be reused. However they should be
inspected for damage after deployment. Replace it with new
deployment harness, if necessary.
• For seat belt pretensioner :
Seat belt pretensioner connector of adapter cable (special
tool) should be inspected for damage when seat belt preten-
sioner is activated. Replace it with spare connector (special
tool), if necessary.
NOTE:
Do not reuse faulty seat belt pretensioner connector of
adapter cable (special tool) because it can be destroyed
by shock when seat belt pretensioner is activated.
23) With air bag (inflator) modules deployed and seat belt pre-
tensioners activated, vehicle may be scrapped in the same
manner as non-air bag system/seat belt pretensioner
equipped vehicle.
NOTE:
Remaining steps are to be followed in the unlikely event
that air bag (inflator) module did not deploy or seat belt
pretensioner did not activate.
24) Remove undeployed air bag (inflator) module(s) and/or inac-
tivated seat belt pretensioner(s) from vehicle as follows.
• For driver air bag (inflator) module :
Remove driver air bag (inflator) module from steering wheel
referring to "Driver Air Bag (inflator) Module" in Section 3C.
AIR BAG SYSTEM 10B-95