Suzuki Wagon R Manual page 1636

1
1 2 3 4
9 10 11 12 13 14 15
V
Power door lock system circuit check
Terminal Wire
G02-6 WHT
G02-9 WHT/GRN Main power supply
G02-11 YEL/BLK Key remainder circuit
G02-12 YEL
G02-13 WHT/BLK
G02-14 WHT/RED
G02-15 BLK/RED Door switch circuit
G02-17 BLK
5) Check that the voltage and resistance between the following
5 6 7 8
16 17 18
Circuit
Power door lock switch circuit
Ignition switch circuit
Driver side key cylinder cir-
cuit (UNLOCK signal)
Driver side key cylinder cir-
cuit (LOCK signal)
Ground
WINDOWS, MIRRORS, SECURITY AND LOCKS 8D-5
terminals and body ground are specifications under each
conditions.
If check result is OK, replace door lock controller. If check
result is not as specified, repair circuit.
1 : Power door lock controller coupler "G02"
Specification
Power door lock switch is pushing
Continuity
position.
Power door lock switch is free posi-
No continuity
tion.
10 – 14 V –
10 – 14 V Ignition key is in ignition switch.
0 – 1 V Ignition key is not in ignition.
10 – 14 V Ignition switch is ON position.
0 – 1 V Ignition switch is OFF position.
Driver side key cylinder is UNLOCK
Continuity
position.
Except the above-mentioned condi-
No continuity
tion.
Driver side key cylinder is LOCK
Continuity
position.
Except the above-mentioned condi-
No continuity
tion.
Driver side, passenger side, rear
0 – 1 V driver side, rear passenger side or
back door is open.
10 – 14 V All doors are close.
0 – 1 V –
Condition