Suzuki Wagon R Manual page 1713

10B-66 AIR BAG SYSTEM
Enabling air bag system
1) Turn ignition switch to "LOCK" position and remove key.
2) Connect contact coil connector (1) and combination switch
assembly by pushing lock lever (2) as shown in figure
securely.
3) Install steering column upper and lower covers.
4) If equipped with passenger air bag (inflator) module, connect
Yellow connector (1) of passenger air bag (inflator) module
by pushing connector till click is heard from it.
5) Install glove box.
6) If equipped with side air bag (inflator) module, connect Yel-
low connector (2) of side air bag (inflator) module, and be
sure to lock connector with lock slider (3).
7) Install "AIR BAG" fuse to circuit fuse box.
8) Turn ignition switch to ON position and verify that "AIR BAG"
warning lamp flashes 6 times and then turns OFF.
If it does not operate as described, perform "AIR BAG DIAG-
NOSTIC SYSTEM CHECK" in this section.