Suzuki Wagon R Manual page 1735

10B-88 AIR BAG SYSTEM
(A)
[A]
10 m (33 ft)
1
(A)
[B]
1
(B)
[C]
10 m (33 ft)
(A)
1
5
(B)
[D]
(A)
10 m (33 ft)
1
7) Stretch deployment harness (A) from air bag (inflator) mod-
8) Place 12 volts vehicle battery (1) near shorted end of deploy-
(B)
9) Verify that area around air bag (inflator) module or seat belt
10) Connect adapter cable (B) as follows.
10 m (33 ft)
11) Connect adapter cable (B) to deployment harness (A) and
2
3
4
ule or seat belt pretensioner to its full length 10 m (33 ft).
Special tool
(A): 09932-75030
ment harness (A).
pretensioner is clear of all people and loose or flammable
objects.
Special tool
(B): 09932-78320
• For driver air bag (inflator) module :
Verify that driver air bag (inflator) module is resting with its
vinyl trim cover facing up, and connect adapter cable (B) to
driver air bag (inflator) module.
• For passenger air bag (inflator) module :
Verify that passenger air bag (inflator) module is firmly and
properly secured on deployment fixture (special tool).
• For side air bag (inflator) module :
To turn over seat back trim (6) and disconnect side air bag
(inflator) module connector (7), then connect adapter cable
(B) to side air bag (inflator) module.
• For seat belt pretensioner :
a) Connect adapter cable (B) to seat belt pretensioner.
b) Pile 2 wheel-installed tires (2) on top of tire with seat belt
pretensioner (3), and tie them with wire harness (4) as
shown.
Wire harness specification:
Stripped wire harness section 1.25 mm
more (Stripped wire harness diameter 1.25 mm (0.05 in.)
or more)
NOTE:
Wind wire harness (4) around at least 2 times.
c) Drape blanket (5) over those tires.
lock connector with lock slider or lock lever.
[A]: For driver air bag (inflator) module
[B]: For passenger air bag (inflator) module
[C]: For side air bag (inflator) module
[D]: For seat belt pretensioner
2 2
(0.0019 in. ) or