Dtc B1013: Sdm Internal Failure - Suzuki 2006 SX4 Service Manual

8B-25 Air Bag System:
Step
7 Serial communication circuit check
1) With ignition switch turned OFF, disconnect SDM
connector "L04" and check for proper connection at
SDM connector terminal.
2) If connections are OK, check that "Serial data circuit" is
as follows.
• Insulation resistance of "Serial data circuit" wire is
infinity between its terminal and other terminals at
SDM connector.
• Insulation resistance of "Serial data circuit" wire is
infinity between its terminal and vehicle body ground.
Is circuit in good condition?
8 Scan tool operation check
1) Check if communication is possible by making
communication with other vehicles.
Is it possible to communicate with the other vehicle?

DTC B1013: SDM Internal Failure

DTC Detecting Condition and Trouble Area
DTC detecting condition
Malfunctioned SDM internal circuit, G sensor, memory or CPU. • SDM
NOTE
DTC B1013 can never be cleared once it has been set.
DTC Troubleshooting
Step
1 Was "Air Bag Diagnostic System Check Flow" performed?
2 DTC check
1) Clear DTC referring to "DTC Clearance".
2) Turn OFF ignition switch.
3) Turn ON ignition switch and check DTC.
Is DTC B1013 still indicated?
3 SDM power supply and ground circuit check
1) Check SDM power supply and ground circuit referring to
"SDM Power Supply and Ground Circuit Check".
Is SDM power supply and ground circuit in good condition?
NOTE
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components and ensure all components are properly mounted.
• Clear DTCs referring to "DTC Clearance", if any.
• Repeat "Air Bag Diagnostic System Check" to confirm that the trouble has been corrected.
Action
Action
Yes
Go to Step 8.
Scan tool is in good
condition, check
intermittent trouble
referring to "Intermittent
and Poor Connection
Inspection in Section
00".
Trouble area
Yes
Go to Step 2.
Go to Step 3.
Substitute a known-
good SDM and recheck.
No
Repair or replace
defective circuit.
Recheck PCMCIA card
and DLC cable for faulty
condition. If they are
OK, scan tool is faulty.
S6RW0C8204010
No
Go to "Air Bag
Diagnostic System
Check Flow"
Intermittent trouble.
Check for intermittent
referring to "Intermittent
and Poor Connection
Inspection in Section
00".
Repair power supply
and ground circuit.