Ignition Timing - Suzuki Ignis Service Manual

6F1-8 IGNITION SYSTEM (ELECTRONIC IGNITION SYSTEM)
(C)
D
E

IGNITION TIMING

NOTE:
• Ignition timing is not adjustable. If ignition timing is
out of specification, check system related parts.
• Before starting engine, place transmission gear shift
lever in "Neutral" (shift selector lever to "P" range for
A/T model), and set parking brake.
INSPECTION
1) When using SUZUKI scan tool, connect SUZUKI scan tool to
DLC with ignition switch OFF.
Special tool
(A) : 09931-76011 (SUZUKI scan tool)
(B) : Mass storage cartridge
(C) : 09931-76030 (16/14 pin DLC cable)
2) Start engine and warm it up to normal operating tempera-
ture.
3) Make sure that all of electrical loads except ignition are
switched off.
(A)
4) Check to be sure that idle speed is within specification.
(Refer to Section 6E1)
(B)
5) Fix ignition timing to initial one as follows.
Select "MISC" mode on SUZUKI scan tool and fix ignition
timing to initial one.
1
If scan tool is not available (vehicle without immobilizer indi-
cator lamp), connect D and E terminals of monitor connector
(1) by using service wire so that ignition timing is fixed on ini-
tial one.
6) Using timing light (1), check that ignition timing is within
specification.
Initial ignition timing (test switch terminal grounded or
fixed with SUZUKI scan tool)
±
: 5 3° BTDC at idle speed
Ignition order
: 1-3-4-2