Table of Contents
Advertisement
6H-10 CHARGING SYSTEM
DISMOUNTING
1) Disconnect negative cable (1).
2) Disconnect positive cable (2).
3) Remove retainer (3).
4) Remove battery (4).
5. Body ground bolt
6. Nut
HANDLING
When handling battery, following safety precautions should be
followed:
• Hydrogen gas is produced by battery. A flame or spark near
battery may cause the gas to ignite.
• Battery fluid is highly acidic. Avoid spilling on clothing or
other fabric. Any spilled electrolyte should be flushed with
large quantity of water and cleaned immediately.
REMOUNTING
1) Reverse removal procedure.
2) Torque battery cables to specification.
NOTE:
Check to be sure that ground cable has enough clear-
ance to hood panel by terminal.
Tightening torque
Body ground bolt (a): 8.0 N·m (0.8 kg-m, 6.0 lb-ft)
GENERATOR
GENERATOR BELT
Refer to "WATER PUMP BELT" in Section 6B "ENGINE COOL-
ING".
Advertisement
Table of Contents
