Operating Mode" Tab; Setting The Operating Mode - Siemens Gigaset M 101 Data Operating Instructions Manual

Configuration program options

"Operating mode" tab

Setting the operating mode

14
Important:
If one station is set to "AT commands, local" or "AVM/Eumex
commands, local", the other station must switch to the corre-
sponding "AT commands, remote" or "AVM/Eumex commands,
remote" operating mode. And if one station is switched to "Di-
rect connection", the other station must also be switched to this
mode. The appropriate switches are performed automatically if
you select an operating mode for an Gigaset M101 Data unit.
Open the Operating mode tab and select one of the five modes:
The three connection types are used for different purposes:
Direct connection The transmission parameters for the PC's
COM port are manually set at the compu-
ter without automatic baud rate or data for-
mat recognition. This is always useful if the
device at the Partnerstation does not sup-
port baud rate or data format recognition
as performed by conventional modems,
e.g. in the case of a second PC.
AT commands Automatic recognition of the transmission
lokalen Station parameters based on the data from the PC
(PC) at the lokalen Station.
page 33
AT commands Automatic emulation of the transmission
Partnerstation parameters based on the values received
(device) from the PC at the Partnerstation.
page 33
AVM / Eumex Automatic recognition of the AVM / Eumex
lokalen Station transmission parameters based on the
(PC) data from the PC at the lokalen Station.
page 34