10. Ipv6 Multicast Commands; Ipv6 Multicast Forwarder - D-Link 5000 Series Cli Reference Manual

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide

10. IPv6 Multicast Commands

In this chapter, the IPv6 Multicast commands available in the D-LINK OS CLI are described.
The commands described in this chapter belong to one of the three following functional groups:
•
Show commands, which are commands that cause switch settings, statistics, and other
information to be displayed
•
Configuration commands, which are commands that cause the features and options of the given
switch to be configured. For every configuration command, there is a corresponding show
command that can be used to display the configuration setting.
•
Clear commands, which are commands that cause some or all of the settings to be reset to
factory defaults.

IPv6 Multicast Forwarder

10-1 ipv6 mroute
Configures an IPv6 Multicast Static Route for a source.
The no command removes the configured IPv6 Multicast Static Route.
ipv6 mroute src-ip-addr src-mask rpf-addr [interface] preference
no ipv6 mroute src-ip-addr
Parameters
src-ip-addr
src-mask
rpf-addr
interface
preference
Default
The default is not configured with any MRoute.
Command Mode
Global Config
10-2 show ipv6 mroute
Note: No specific IP multicast is enabled for IPv6. However, enabling of multicast at the global config for
both IPv4 and IPv6 is common.
The IP address of the multicast source network.
The IP mask of the multicast data source.
The IP address of the RPF next-hop router toward the source.
(Optional) Specify the interface if the RPF Address is a link-local
address.
The administrative distance for this Static MRoute, that is, the
preference value. The range is 1 to 255.
987