Diagnostic - ZyXEL Communications XS3800-28 User Manual

The following table describes the labels in this screen.
Table 365 MAINTENANCE > Configuration > Configure Clone
LABEL
Configure Clone
Source/
Destination
Port Features
Port
SYSTEM
PORT
SWITCHING
NETWORKING
SECURITY
Apply
Cancel

87.14 Diagnostic

Click MAINTENANCE > Diagnostic in the navigation panel to open this screen. Use this screen to ping IP
addresses, run a traceroute, perform port tests or show the Switch's location between devices.
Chapter 87 MAINTENANCE
DESCRIPTION
In Stacking mode, a port is defined by a slot ID representing the Switch in the stack and a port
number.
Select the source port and slot (in Stacking mode) under the Source label. This port's attributes are
copied.
Enter the destination port or ports under the Destination label. These are the ports which are going
to have the same attributes as the source port. You can enter individual ports separated by a
comma or a range of ports by using a hyphen. For example, 2, 4, 6 indicates that ports 2, 4 and 6
are the destination ports. 2-6 indicates that ports 2 through 6 are the destination ports.
In Stacking mode, you can select multiple destination slots.
Select * to apply all settings to the port. Use this first to select the common settings and then
remove the settings you do not want copied.
Select a feature's check box to select a specific feature. Otherwise, select the check box in the
table heading row to select all features for a category.
Select the system feature (you configured in the SYSTEM menus) to be copied to the destination
ports. Otherwise, select the SYSTEM check box in the table heading row to select all features for a
category.
Select which port features (you configured in the PORT menus) should be copied to the
destination ports. Otherwise, select the PORT check box in the table heading row to select all
features for a category.
Select which switching features (you configured in the SWITCHING menus) should be copied to
the destination ports. Otherwise, select the SWITCHING check box in the table heading row to
select all features for a category.
Select the networking feature (you configured in the NETWORKING menus) to be copied to the
destination ports. Otherwise, select the NETWORKING check box in the table heading row to
select all features for a category.
Select which security features (you configured in the SECURITY menus) should be copied to the
destination ports. Otherwise, select the SECURITY check box in the table heading row to select all
features for a category.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XS3800-28 User's Guide
679