General Alarm Command Parameters; Table 131 Alarm Commands; Table 132 General Alarm Command Parameters - ZyXEL Communications MSC1000G User Manual

MSC1000G User's Guide
Table 131 alarm Commands (continued)
COMMAND
set
show [<severity>|all
] [<alarm>|all]
[<condition>|al
l]
[<sdate>|all]
[<edate>|all]
[for|rev]
[detail]
tablelist [<alarm>|all]
[<severity>|all
] [<fac>|all]
[<target>[,<tar
get>]]
[<condition>|al
l]
xedit <alarm> <cond>
<severity>
<fac>
<target>[,<targ
et>]
<clearable>

18.2 General alarm Command Parameters

The following table describes commonly used

Table 132 General alarm Command Parameters

NOTATION
<alarm>
<severity>
<condition>
<sdate>
<edate>
318
<all|sub1|sub2|
up1|up2|mgmt
|slot-port>
<severity>
DESCRIPTION
Specify a category of alarms.
eqpt
represents equipment alarms.
dsl represents Digital Subscriber Line (DSL) alarms.
enet represents Ethernet alarms.
sys represents system alarms.
all specifies every alarm category.
Specify an alarm severity level (
Specify an alarm condition.
Specify a start date in yyyy/mm/dd format.
Specify an end date in yyyy/mm/dd format.
DESCRIPTION
Sets the severity of alarms to record for
individual ports.
Displays current alarms by severity,
alarm category or alarm condition. You
can also display detailed alarms.
Displays the supported alarm list and
report settings.
<fac> = local1~local7
<target> = snmp|syslog|all
Sets the severity level of an alarm(s)
and where the system is to send the
alarm(s).
<cond> = <condition>|<code>|all
<target> = snmp|syslog
|all|none
'none' disables alarm
reports on this alarm category.
<clearable> = clearable|unclearable
command parameter notation.
alarm
critical , major , minor
Chapter 18 alarm Commands
P
M
L
L
M
, info or all ).