Config-Vlan Commands; Table 94 Interface Route-Domain Commands; Table 95 Command Summary: Config-Vlan Commands - ZyXEL Communications ES-2724 User Manual

Use these commands to configure the IP routing domains.

Table 94 interface route-domain Commands

COMMAND
interface
route-domain
<ip-address>/
<mask-bits>
exit
ip
no

39.11.6 config-vlan Commands

The following table lists the

Table 95 Command Summary: config-vlan Commands

COMMAND
vlan <1-
4094>
exit
fixed <port-
list>
Chapter 39 Introducing Commands
igmp <v1|v2>
igmp robustness-
variable <2-255>
igmp query-interval
igmp query-max-
response-time <1-25>
igmp last-member-
query-interval <1-
25>
rip direction
<Outgoing|Incoming|
Both|None>
ip igmp
commands in configuration mode.
vlan
ES-2724 User's Guide
DESCRIPTION
Enables a routing domain for
configuration.
Exits from the interface routing-
domain command mode.
Enables IGMP in this routing
domain.
Sets the igmp robustness variable
on the switch. This variable
specifies how susceptible the
subnet is to lost packets.
Sets the igmp query interval on
the switch. This variable specifies
the amount of time in seconds
between general query messages
sent by the router.
Sets the maximum time that the
router waits for a response to an
general query message.
Sets the amount of time in
seconds that the router waits for a
response to a group specific
query message.
Sets the RIP direction in this
routing domain.
Disables IP IGMP in this routing
domain.
DESCRIPTION
Creates a new VLAN group.
Leaves the VLAN configuration
mode.
Specifies the port(s) to be a
permanent member of this VLAN
group.
PRIVILEG
E
13
13
13
13
13
13
13
13
13
PRIVILEGE
13
13
13
263