Omron R88M-K User Manual page 280

4 System Design
3
Open the wire insertion slots in the terminal block using a tool.
There are 2 ways to open the wire insertion slots, as follows.
• Pry the slot open using the lever that comes with the Servo Drive. (Figure A)
• Insert a flat-blade screwdriver (end width: 3.0 to 3.5 mm) into the opening for the driver on the
terminal block, and press down firmly to open the slot. (Figure B)
4
With the wire insertion slot held open, insert the end of the wire.
After inserting the wire, let the slot close by releasing the pressure from the lever or the
screwdriver.
5
Mount the terminal block to the Servo Drive.
After all of the terminals have been wired, return the terminal block to its original position on the
Servo Drive.
Note The wire may not be inserted easily depending on the shape of the ferrule connected to it.
If this occurs, perform one of the following methods before inserting the wire.
• Change the direction of inserting the connector by 90 degrees.
• Correct the shape of the ferrule with pliers.
4-34
Figure A
G5-series AC Servomotors and Servo Drives User's Manual (with Built-in EtherCAT Communications)
Figure B