Omron R88M-K User Manual page 250

4 System Design
Connecting to Mechanical Systems
• For the allowable axial loads for motors, refer to
3-1-2 Characteristics on page 3-3. If an axial load
greater than that specified is applied to a motor, it
may reduce the limit of the motor bearings and
may break the motor shaft.
• When connecting to a load, use couplings that
can sufficiently absorb mechanical eccentricity
and declination.
• For spur gears, an extremely large radial load
may be applied depending on the gear precision.
Use spur gears with a high degree of precision
(for example, JIS class 2: normal line pitch error
of 6 µm max. for a pitch circle diameter of
50 mm).
• If the gear precision is not adequate, allow
backlash to ensure that no radial load is placed
on the motor shaft.
• When using bevel gears, a load is applied in the
thrust direction depending on the structural
precision, the gear precision, and temperature
changes. Provide appropriate backlash or take
other measures to ensure that a thrust load larger
than the specified level is not applied.
• Do not put rubber packing on the flange surface.
If the flange is mounted with rubber packing, the
motor flange may crack under the tightening
force.
• When connecting to a V-belt or timing belt,
consult the manufacturer for belt selection and tension.
• A radial load twice as large as the belt tension will be placed on the motor shaft. Do not allow a load
that exceeds the allowable radial load to be placed on the motor shaft. If an excessive radial load is
applied, the motor shaft and bearings may be damaged.
• Set up a movable pulley in the middle of the motor shaft and the load shaft so that the belt tension
can be adjusted.
Water and Drip Resistance
• The protective structure for the motors is as follows:
Equivalent to IP67 (except for through-shaft parts and motor connector pins and encoder connector
pins)
4-4
Pulley
Belt
Tension
G5-series AC Servomotors and Servo Drives User's Manual (with Built-in EtherCAT Communications)
Motor center line
Backlash
Set a movable structure.
Tension adjustment (Set a movable structure.)
Ball screw center line
Axial offset Axial offset Axial offset
Set a structure in which
the distance between
axes can be adjusted.
Bevel gear