Jp/Gp.recv (Receiving Data From The Programmable Controller On Another Station) - Mitsubishi Electric QJ71GF11-T2 User Manual

10.9
JP/GP.RECV (Receiving Data from the Programmable
Controller on Another Station)
This instruction reads the data received from the programmable controller on another station. (For the main routine
program)
JP.RECV
GP.RECV
Setting
Internal device
1
(System, user)
data*
Bit Word

(S1)

(D1)
(D2)
*1 Local devices and file registers set for each program cannot be used.
(1) Setting data
Setting data
Jn
Un
(S1)
(D1)
(D2)
294
Start contact
Start contact
Link direct device
File
J\
register
R, ZR
Bit Word
Description
Own station's network No. (1 to 239, 254)
254: Network specified in Valid Module During Other Station Access
Start I/O number of the master/local module of the own station
(00 to FE : Upper two digits of the I/O number expressed in three
H
digits)
Start device of the own station where control data is stored
Start device of the own station where received data is stored
(A continuous area for the received data length is required.)
The device of the own station that turns on for one scan upon
completion of the instruction.
If the instruction fails, (D2)+1 also turns on.
JP.RECV Jn
GP.RECV Un
Available devices
Intelligent function
module device
U\G



(S1) (D1) (D2)
(S1) (D1) (D2)
Constant
Index register
Zn
K, H $
Set by
16-bit binary
User
Device name
System
Bit
Others
Data type