Acx6160 Chassis Status Leds - Juniper ACX6160 Hardware Manual

3 Pull-out tab with customer asset ID label
—
QSFP28 Network Ports
The ACX6160 has eight (client) network ports (0/0 through 0/7) that support QSFP28 transceivers.
Currently (only the even ports of QSFP28, ports 0/0, 0/2, 0/4, 0/6 are supported). These transceivers
provide a speed of 100 Gbps, through four 25-Gbps channels. The ports are configured as 100-Gigabit
Ethernet ports by default.
CFP2-DCO Network Ports
The ACX6160 has four line CFP2 network ports (1/0 through 1/3) that support C form-factor pluggable
type 2 transceivers.

ACX6160 Chassis Status LEDs

The ACX6160 has three status LEDs located on the left of the port panel, adjacent to the client port 0/0
(see Figure 4 on page 8). The system status LEDs that alert you to minor or major alarms or other
issues with the router, external clock synchronization ports.
Figure 4: ACX6160 Chassis Status LEDs
1 Status LEDs—Alarm (ALM), system (SYS),
—
identification (ID).
Table 4 on page 9 describes the chassis status LEDs (located on the left side of the front panel) on an
ACX6160, their colors and states, and the status they indicate.
6 RJ-45 (1000BASE-T) management Ethernet
—
port (labeled MGMT).
8