Add Oscilloscope Waveform to the Timing Waveforms
To see the correlation between the timing analyzer and the oscilloscope, you
must insert the scope display into the timing waveform display.
Press the
1
Highlight the large field at the left side of the display. The TCOUNT
2
label should be displayed in the large field.
If the TCOUNT label is not in the large field, then you need to add it. To add
the TCOUNT label, highlight the large field, then press the Select key twice.
Choose Insert, Analyzer, TCOUNT, then Sequential in the pop-up menus.
Using the knob, place the cursor on the
3
Press the
4
Choose
5
menus.
The oscilloscope
waveform is added to the
analyzer display.
Adding Oscilloscope Waveform to the Timing Waveforms
Result
Both the timing waveform for TCOUNT and the oscilloscope waveform will be
displayed when you run the analyzer.
Triggering the Oscilloscope with the Timing Analyzer
Add Oscilloscope Waveform to the Timing Waveforms
Wform
MENU key to display the Waveform Machine1 menu.
key.
Select
,
, then
(oscilloscope channel 1) in the pop-up
Insert
Scope
C1
Get other manuals https://www.bkmanuals.com
TCOUNT 7
label.
8-13