Cli Operations; Cli Main Menu - Comtech EF Data CDM-570A Installation And Operation Manual

CDM-570A/570AL Satellite Modem with Optional Packet Processor
Optional Packet Processor - Serial/Telnet CLI Operation
9.3

CLI Operations

Figure 9-2 show use of HyperTerminal as configured for Telnet CLI. The appearance
of this interface may vary across individual user configurations. The remainder of
this chapter shows the CLI pages as they appear with any user-supplied terminal
emulator.
9.3.1

CLI Main Menu

Selection
Administration
Interface Configuration
QoS Configuration
Route Table
Protocol Configuration
Satellite Modem Configuration
Redundancy Configuration
Operations and Maintenance
Figure 9-2. Main Menu
Hot Key Description
Provides a basic set of standard administrative functions to the
A Packet Processor. When connected via Telnet, navigation to this
menu is restricted to the Admin user.
I Configures the Ethernet and Satellite interfaces.
Q
Defines QoS rules for up to 32 different types of flows.
Defines how the Packet Processor will route packets that it receives
R
on its Ethernet and Satellite interfaces.
Configures various protocols – including ARP, IGMP, DHCP, and
P
BRouter – used by the Packet Processor.
Displays menus that are used to configure and monitor the Base
M
Satellite Modem.
E
Configures 1:1 IP Redundancy.
Configures various options for system control and maintenance;
O
provides Statistics and diagnostic tools for troubleshooting purposes.
9–7
MN-CDM570A
Revision 3