Comtech EF Data CDM-570A Installation And Operation Manual page 362

CDM-570A/570AL Satellite Modem with Optional Packet Processor
Optional Packet Processor - Serial/Telnet CLI Operation
Selection
Upgrade To
Base Modem Boot From
Codecast Multicast Address
PARAM Image
Statistics
Event Log
Database Operations
Reset
Diagnostics
M&C Interface
Hot Key Description
U Select which Packet Processor or Base Modem firmware image
(includes Application, FPGA, and FFPGA) is overwritten in the Firmware
Update FTP process:
0 – Oldest: Updates the older firmware image based upon date.
1 – Image1: Updates the firmware image loaded into the first slot in
permanent storage.
2 – Image2: Updates the firmware image loaded into the second slot
in permanent storage.
A Select which Base Modem firmware image is loaded upon bootup. The
possible options are:
0 – Latest: Boot the newer firmware package based upon date.
1- Image1: Boot the firmware image loaded into the first slot in
permanent storage.
2 – Image2: Boot the firmware image loaded into the second slot in
permanent storage.
M Set the Multicast address used by VLOAD to upgrade the modem
firmware and param file via streaming Multicast. Must match the
address specified in VLOAD.
C Select the PARAM file that is loaded on bootup:
1 – Last saved Parameter file
2 -Factory – uses the internal, hard-coded factory default parameters.
T
Displays the Statistics page.
E Displays the Event Log page.
D Displays the Database Operations page.
R
Reboots the modem (including the Packet Processor). It has the same
logical effect of power-cycling the unit.
G
Displays the Diagnostics page.
F Allows base modem communications debugging.
9–62
MN-CDM570A
Revision 3