Comtech EF Data CDM-570A Installation And Operation Manual page 271

CDM-570A/570AL Satellite Modem with Optional Packet Processor
Serial-based Remote Product Management
Command
Parameter (Instruction
Type Code and
Qualifier)
Retrieve next 5
unread Stored
Events (continued)
Clear All Stored CAE= None
Events
Initialize Events IEP= None
Pointer
Statistics Sample SSI= 1 byte, numerical
Interval
Number of Unread N/A 3 bytes
stored Statistics
Clear All Stored CAS= None
Statistics
Initialize Statistics ISP= None
Pointer
Arguments for
Command or
Response to
Query
1 = Power On
2 = Log Cleared
3 = Global Config Change
4 = Redundancy Config Change
Notes:
1) If less than 5 events are to be retrieved, the remaining positions are padded with
zeros.
2) If there are no new events, the response is RNE*.
Command only.
This command takes no arguments.
Forces the software to clear the software events log.
Command only.
This command takes no arguments.
Resets internal pointer to allow RNE? queries to start at the beginning of the stored
events log.
Command or Query.
Sets or returns the sample interval for the Statistics Logging Function in the form x,
where:
x = 0 to 9 in 10 minute steps.
Note: Setting this parameter to 0 disables the statistics logging function.
Example: <0/SSI=3 (30 minutes)
Query only.
Returns the number of stored statistics that remain unread over the remote interface
in the form xxx.
Example: <0/NUS?
>0/NUS=247
Command only.
This command takes no arguments.
Forces the software to clear the software statistics log
Command only.
This command takes no arguments.
Resets internal pointer to allow RNS? queries to start at the beginning of the
statistics log.
Description of Arguments
8–27
MN-CDM570A
Revision 3
Query
Response to
(Instruction Code
Command
and Qualifier)
CAE= N/A N/A
CAE?
CAE*
CAE#
IEP= N/A N/A
IEP#
SSI= SSI? SSI=x (see
SSI? Description of
SSI* Arguments)
SSI#
N/A NUS? NUS=xxx (see
Description of
Arguments)
CAS= N/A N/A
CAS?
CAS*
CAS#
ISP= N/A N/A
ISP#
Response to
Query