Working Mode = Router Mode (Point-To-Multipoint / Point-To-Point / Vipersat; Configure Router Mode; Figure Q-7. Cdm-570A/570Al Router Mode Ip Addresses - Comtech EF Data CDM-570A Installation And Operation Manual

CDM-570A/570A Satellite Modem with Optional Packet Processor
Appendix Q
Q.4 Working Mode = Router Mode (Point-to-Multipoint / Point-to-Point /
Vipersat)
Q.4.1

Configure Router Mode

Do these steps:
1. Use the CDM-570A/570AL Serial CLI to set your active Router Working Mode. As shown
previously in Figure Q-4from the Administration menu, press '
choices:
Press For Router Mode:
1 Small Network
2 Large Network
3 Point to Point
4 Vipersat
5 Managed Switch
2. Enable Dedicated Management Port operation. As shown previously in Figure Q-3, on the
Ethernet Interface menu, press '
choices; then, press '2' to Enable.
3. Dedicated Management Port, when used in Router Mode, requires two IP Addresses (Figure
Q-7):
•
One for M&C (management) – the '10/100 Ethernet | M&C 100' port;
• One for Traffic (Ethernet data) – the Traffic 100 port.
When Dedicated Management Port is disabled, the existing Management IP
Address is used for both M&C and traffic.
Description
Router uses 1 byte HDLC addresses
Router mode using 2 byte HDLC addresses
Router mode uses 0 HDLC addresses to save satellite bandwidth
Router mode when running in a Vipersat Network
N/A (see Sect. Q.3)
' to display the Dedicated Management Port operation
D

Figure Q-7. CDM-570A/570AL Router Mode IP Addresses

Q–7
MN-CDM570A
Revision 3
' to display the available
C