Config: Ti (Data Traffic Interface); Config: Ti) Rs422 Or V.35 Or Rs232; Config: Ti) Ip - Comtech EF Data CDM-570A Installation And Operation Manual

CDM-570A/570AL Satellite Modem with Optional Packet Processor
Front Panel Operation
6.3.2.7

CONFIG: TI (Data Traffic Interface)

Data Interface: RS422 IP
V.35 RS232 G.703 IP-ACM
◄ ►
Use the arrow keys to select a parameter. Press ENTER.
6.3.2.7.1

(CONFIG: TI) RS422 or V.35 or RS232

RTS/CTS Operation: (▲ ▼)
Loop,RTS Controls Tx Out
For RS422, V.35, or RS232, the modem displays this typical submenu. Use the ▲▼arrow keys to
select an option. Press ENTER.
Parameter
RTS/CTS Loop, No Description
Loop, RTS Controls Tx Out
Ignore RTS, Assert CTS
N/A - 1:N system in use
6.3.2.7.2

(CONFIG: TI) IP

This selection is functional only when the optional Packet Processor is installed.
Select IP to toggle the optional Packet Processor operation. Once you select IP, the modem
returns you to the SELECT: Config menu branch.
6.3.2.7.3 (CONFIG: TI) G.703
G.703 Type:
E1-Bal E1-Unbal(◄ ►,ENT)
◄ ►
Use the arrow keys to select T1, E1-Bal, or E1-Unbal. Press ENTER.
(CONFIG: TI) G.703  T1
T1 Configuration: Length
Line-Code
Description
RTS and CTS are looped, so that CTS echoes the state of RTS, but RTS
does not control the ON/OFF state of the carrier.
RTS and CTS are looped, so that CTS echoes the state of RTS, and RTS
controls the ON/OFF state of the carrier (in other words, the modem will not
bring up its TX carrier until RTS is asserted).
RTS is ignored and CTS is asserted unconditionally.
If the 1:N switch on the rear panel is active, then RTS/CTS are not supported;
the pins are assigned to redundancy functions.
T1
(◄ ►,ENTER)
6–33
MN-CDM570A
Revision 3