Comtech EF Data CDM-570A Installation And Operation Manual page 128

CDM-570A/570AL Satellite Modem with Optional Packet Processor
Front Panel Operation
Warning! AUPC needs
Framed Mode or IP-ACM
This indicates Manual mode is active. Press ENTER or CLEAR to return to the previous
menu.
• If you select IP-ACM mode, and you then select AUPC, the modem displays the AUPC
submenu as follows:
Target-Eb/No
Alarm DemodUnlock (◄ ►)
•
If you select EDMAC or EDMAC-2 framed mode, but not IP-ACM mode, and you then
select AUPC, the modem displays the AUPC submenu as follows:
Max-Range
DemodUnlock
◄ ►
Use the
(CONFIG: Tx) Output Power Level Mode: AUPC  Target-E
Remote Demod - Target
Min Eb/No:14.9dB (◄ ►,▲ ▼)
To edit the Remote Demod Target E
then use the ▲▼arrow keys to change that digit. The default value is 3.0 dB, and the
upper limit is 14.9 dB. Press ENTER.
(CONFIG: Tx) Output Power Level Mode: AUPC  Max-Range
Maximum-permitted Power
increase: 1dB
Use the ▲▼arrow keys to change the value of maximum permitted increase in power
level (when in AUPC mode). Press ENTER. The default value is 1 dB, and the upper
limit is 9 dB.
(CONFIG: Tx) Output Power Level Mode: AUPC  Tx-Alarm or
Alarm
Action when max Tx Power
reached: None TxAlarm ◄ ►
To set the action that occurs if the AUPC causes the maximum output power level to be
reached, use the
Max-Range
Tx-Alarm
arrow keys to select a parameter. Press ENTER.
(▲ ▼,ENT)
◄ ►
arrow keys to select None or TxAlarm. Press ENTER.
(◄ ►)
◄ ►
/N , use the arrow keys to select a digit, and
b 0
6–20
MN-CDM570A
Revision 3
/N
b 0