Configuration | Arp - Comtech EF Data CDM-570A Installation And Operation Manual

CDM-570A/570AL Satellite Modem with Optional Packet Processor
Ethernet-based Remote Product Management
Delete VLAN Entry (with optional Packet Processor INSTALLED)
Enter Entry Index to Delete, and then click [Delete Entry]. The entry will then be deleted from
the VLAN Table.
Make sure to also click [Save PaP Parameters] on the 'Admin | PaP Save' page before
proceeding further .
7.4.3.3.3

Configuration | ARP

1) This page is available only to Admin users and when you install the optional
Packet Processor.
2) If you submit any changes to this page, you must also open the 'Admin | Pap
Save' page (see Chapter Sect. 7.4.3.2.7) and immediately click [Save PaP
Parameters].
ARP (Address Resolution Protocol) is a technique by which the HTTP Interface in Router Mode
on a given network answers the ARP queries for a network address that is not on this network,
but is reachable via the Packet Processor Interface.
Use this page to configure the modem's ARP parameters.
Figure 7-14. Configuration | LAN | ARP Page
7–32
MN-CDM570A
Revision 3