Operations And Maintenance > Diagnostics - Comtech EF Data CDM-570A Installation And Operation Manual

CDM-570A/570AL Satellite Modem with Optional Packet Processor
Optional Packet Processor - Serial/Telnet CLI Operation
9.3.10.5 Operations and Maintenance > Diagnostics
Open the nested Diagnostics Page from the Operations and Maintenance page.
Using Dump Packets Diagnostics Utilities
1) The Dump Packet Utilities will display a hexadecimal representation of each
packet and
network.
Type the Hot Key a second time to terminate the dump operation. Each
2)
selection toggles the value of the dump engine.
Selection
Dump Packets transmitted
to Satellite Interface
Dump Packets received
from Satellite Interface
Dump Packets transmitted
to Ethernet Interface
Dump Packets received
from Ethernet Interface
Dump Packets received
by Router
Dump Packets sent to
EndStation
Dump Packets received
from EndStation
Ping
Traceroute
Command Line Debug
Prompt
Figure 9-59. Diagnostics
should not
be used when the Packet Processor is on a "live"
Hot Key Description
T Toggle [Yes] to force the Packet Processor to dump a hexadecimal
representation of each packet transmitted over the Satellite Interface.
R Toggle [Yes] to force the Packet Processor to dump a hexadecimal
representation of each packet received from the Satellite Interface.
U Toggle [Yes] to force the Packet Processor to dump a hexadecimal
representation of each packet transmitted to the Ethernet Interface.
V Toggle [Yes] to force the Packet Processor to dump a hexadecimal
representation of each packet received from the Ethernet Interface.
B Toggle [Yes] to force the Packet Processor to dump a hexadecimal
representation of each packet received by the routing engine.
Note: Does not apply when in Managed Switch Mode.
G Toggle [Yes] to force the Packet Processor to dump a hexadecimal
representation of each packet received by and destined for this modem.
This traffic includes Pings, SNMP, Telnet, HTTP, and FTP traffic types.
H Toggle [Yes] to force the Packet Processor to dump a hexadecimal
representation of each packet sourced from this modem and destined for
some other device. Select this to see what type of packets this modem is
generating internally.
P
Set the IP address in aaa.bbb.ccc.ddd format, set the number of pings to be
sent. Reports percentage of packet loss and round trip time (RTT) in msec
(min/avg/max).
A
Set the IP address in aaa.bbb.ccc.ddd format. Reports min/avg/max RTT
for each hop in path.
D This is reserved for Customer Service and engineering use.
Type your password to access the debug command line.
9–78
MN-CDM570A
Revision 3