Comtech EF Data CDM-570A Installation And Operation Manual page 323

CDM-570A/570AL Satellite Modem with Optional Packet Processor
Optional Packet Processor - Serial/Telnet CLI Operation
Selection
Traffic Port Speed/Mode
Mgmt IP Address
Subnet Prefix Length
DM/Red Traffic MAC Address
DM/Red Traffic IP Addr
DM/Red Traffic Subnet Prefix
Traffic Port Actual Speed
Dedicated Management Port
Hot Key Description
E This is a configurable parameter and, as such, its exact setting can
vary between specific installations. The default setting allows the
Ethernet port to auto-negotiate its link speed on power-up. Selections
are:
1 – Auto (default)
2 – 10 MB/sec Half Duplex
3 – 100 MB/sec Half Duplex
4 – 10 MB/sec Full Duplex
5 – 100 MB/sec Full Duplex
I Select this to assign the IP Address for the Ethernet M&C Interface.
Set the IP address in aaa.bbb.ccc.ddd format
M
Select this to define the Subnet Mask assigned to the Ethernet Traffic
Interface. Set the subnet mask prefix length (8...30)
[RO]
This is the hardware destination MAC Address that is used when an
Ethernet packet is destined for the Packet Processor Traffic Ethernet
Interface. This address is unique and has been assigned permanently
at the factory.
In Managed Switch Mode, this entry is not applicable.
In Router mode this parameter can be configured when either
Redundancy is Enabled Or Dedicated Management Port is Enabled.
In Managed Switch Mode, this entry is not applicable.
In Router mode, this parameter can be configured when either
Redundancy is Enabled Or Dedicated Management Port is Enabled.
[RO]
This displays the current speed and duplex of the Packet Processor
Traffic port.
D
Select this to disable or enable Dedicated Management Port operation.
When Working Mode = Router, selections are:
1 – Disabled (default)
2 – Enabled
9–23
MN-CDM570A
Revision 3