Interface Configuration > Satellite/Hdlc Interface; Interface Configuration > Receive Hdlc Channel Addresses - Comtech EF Data CDM-570A Installation And Operation Manual

CDM-570A/570AL Satellite Modem with Optional Packet Processor
Optional Packet Processor - Serial/Telnet CLI Operation
9.3.3.2 Interface Configuration > Satellite/HDLC Interface
Open the nested Satellite/HDLC Interface page from the Interface Configuration page.
Selection
HDLC Addr Mode
Receive HDLC Channel
Addresses
9.3.3.3 Interface Configuration > Receive HDLC Channel Addresses
Open the nested Receive HDLC Channel Addresses page from the Satellite/HDLC Interface page.
Use this page to define up to four HDLC addresses that can carry user information on the
Satellite Interface.
Selection
HDLC Addr 1 – HDLC
Addr 4
Delete HDLC Addr
Figure 9-12. Satellite/HDLC Interface
Hot Key Description
[RO] • HDLC Address Mode – This mode is configured via the Working
Mode, which is found on the Administration page.
• Point-To-Point Mode – In this mode of operation, no HDLC address is
transmitted over the satellite link. The restrictions on using this mode
are that it can only be used for pure Point-to-Point configurations.
• Small Network Mode (up to 254 addresses) – In this mode of
operation a single byte HDLC address is transmitted over the satellite
link (0x1 – 0xFE).
• Large Network Mode (up to 32766 addresses) – In this mode of
operation a two byte HDLC address is transmitted over the satellite link
(0x1 – 0xFFFE).
H
Displays the Receiver HDLC Channel Addresses page.
Figure 9-13. Receive HDLC Channel Addresses
Hot Key Description
1 – 4 HDLC address in hex <1 – FFFE, enter = 0001>
Note that HDLC addresses are not used in Point-To-Point Mode.
• Small Network Mode (up to 254 addresses) – Limited to valid
addresses between the values of 0x01 and 0xFE.
• Large Network Mode (up to 32766 addresses) – Limited to valid
addresses between the values of 0x0001 and 0x7FFF.
D Set the HDLC entry to delete <1...4>
9–24
MN-CDM570A
Revision 3