Admin | Pap Save - Comtech EF Data CDM-570A Installation And Operation Manual

CDM-570A/570AL Satellite Modem with Optional Packet Processor
Ethernet-based Remote Product Management
7.4.3.2.7

Admin | PaP Save

This page is available only when you install the optional Packet Processor.
You must click [Save PaP Parameters] on this page, in addition to changes made to the following
CDM-570A HTTP Interface pages:
CDM-570A HTTP Interface Page
Admin | Pap Features
Admin | Firmware | Packet Processor
Configuration | LAN (only when the optional Packet Processor
is INSTALLED)
Configuration | ARP
Any nested Configuration | Routing page
Configuration | Managed Switch
Any nested Configuration | WAN page
Redundancy (only when the optional Packet Processor is
INSTALLED)
Note that the modem reboots automatically if any changes are submitted to the 'Admin |
Working Mode' page (see Sect. 7.4.3.2.3).
Figure 7-10. Status | PaP Save Page
7–24
MN-CDM570A
Revision 3
See Chapter Section...
7.4.3.2.4
7.4.3.2.5.2
7.4.3.3.2
7.4.3.3.3
7.4.3.3.4
7.4.3.3.5
7.4.3.3.6
7.4.3.6