Comtech EF Data CDM-570A Installation And Operation Manual page 215

CDM-570A/570AL Satellite Modem with Optional Packet Processor
Ethernet-based Remote Product Management
The information that follows is applicable only when QoS Mode = Rule –
Max/Priority Mode
QoS Max/Priority Rules Table
This section displays all existing QoS Max/Priority Rules Table entries. From left to right:
Column
Index
Protocol
Src IP Addr
Src IP Mask
Src IP Addr
Dest IP Mask
Min Src Port
Max Src Port
Min Dst Port
Max Dst Port
Max BW (Kbps)
Priority
WRED
Filtering
Add New QoS Rule
This section allows you to directly add a new Max/Priority QoS Rule.
•
Protocol / Priority / WRED / Filtering – Use the drop-down list to select the desired
operation.
•
Src IP Mask / Dst IP Addr and Mask / Min and Max Src Port / Min and Max Dst Port / Max
BW (Kbps) – Entire the desired value parameter as needed.
Click [Add Rule] to save. When you add a new rule to the QoS Max/Priority Rules Table, the
modem automatically assigns an internal table index number to the table.
Description
This is the internal table index that is automatically assigned and cannot be edited.
Specifies the protocol for the specific rule.
Identifies the Source IP Address in the form XXX.XXX.XXX.XXX.
Identifies the Source IP Mask in the form YY.
Identifies the Destination IP Address in the form XXX.XXX.XXX.XXX.
Identifies the Destination IP Mask in the form YY.
Specifies the Minimum Source Port.
Specifies the Maximum Source Port.
Specifies the Minimum Destination Port.
Specifies the Maximum Destination Port.
Specifies the Maximum Bandwidth value in kilobits per second.
Specifies the priority established for the specific rule (1-8).
Specifies the WRED (Weighted Random Early Detection) setting for the specific rule as
Disable or Enable.
Specifies the flow filter setting for the specific rule as Disable or Enable.
7–43
MN-CDM570A
Revision 3